Invacare Allegro 1061057 - Manual (Page 21)

21
PROCEDURE 2 ARMS
A
R
M
S
Removing
1. Press in on the locking lever and lift the "T" arm straight
up and out of the "T" arm socket.
NOTE: If the "T" arm does not slide up and down in
the "T" arm socket as desired, adjust the "T" arm
socket. Refer to ADJUSTING THE "T" ARMS in this
section of the manual.
2. Repeat STEP 2 for the opposite side of the wheel-
chair.
B. Loosen - Loosening the set screws on the out-
side "T" arm post will make it easier to move
the inside "T" arm post up and down.
3. Lock the "T" arm by flipping the "T" arm release
lever towards the front of the wheelchair.
FIGURE 2 - INSTALLING/REMOVING THE "T"
ARMS
Width (FIGURE 4)
1. Remove the two (2) phillips screws that secure the
arm pad to the arm tube.
2. Turn the arm pad around and reposition the arm
pad on the arm tube.
3. Re-secure the arm pad to the arm tube with the two
(2) phillips screws.
4. Repeat for the opposite side, if necessary.
FIGURE 4 - ADJUSTING THE "T" ARMS -
WIDTH
Phillips
Screw
Arm Tube
Phillips Screw
Arm Pad
Depth (FIGURE 5)
1. Remove the two (2) phillips screws that secure the
arm pad to the arm tube.
2. Remove the two (2) socket screws that secure the
arm tube to the "T" arm post.
ADJUSTING THE "T" ARMS
Height (FIGURE 3)
1. Unlock the "T" arm by flipping the "T" arm release
lever towards the inside of the wheelchair.
NOTE: If necessary, Pull out on the "T" arm re-
lease lever and rotate 180
o
so it can be flipped
towards the outside of the wheelchair.
2. Slide the "T" arm to one (1) of:
A. Low Height "T" Arms - Nine (9) positions.
B. High Height "T" Arms - Seven (7) positions.
NOTE: If the inside "T" arm post does not slide up
and down in the outside "T" arm post as desired,
perform one (1) of the following:
A. Tighten - Tightening the set screws on the out-
side "T" arm post will make it harder to move
the inside "T" arm post up and down.
FIGURE 3 - ADJUSTING THE "T" ARMS -
HEIGHT
"T" Arm
Socket
Slot
Locking Lever
(Towards the
front of the
wheelchair.)
"T" Arm
Wheelchair
Frame
Set
Screws
"T" Arm Release
Lever - Unlocked
Position
Inside "T"
Arm Post
Outside "T"
Arm Post
"T" Arm Release Lever -
Locked Position