Invacare Allegro 1061057 - Manual (Page 18)

18
Adjusting Calfpads
1. To adjust the calfpad, turn pad towards the
outside of the wheelchair.
2. Slide the calfpad up or down until the desired
position is obtained.
3. To secure the calfpad, turn the calfpad towards the
inside of the wheelchair.
INSTALLING/ADJUSTING ADJUSTABLE
ANGLE FLIP-UP FOOTPLATES
WARNING
When determining the angle of the footplates, make
sure the rear of the footplates do not interfere with
the movement of the front casters.
Installing Adjustable Angle Flip-up Footplates
(FIGURE 7)
1. Slide the half clamp over the footplate hinge.
2. Loosely tighten the two (2) flat bolts, washers and
locknuts that secure the footplate to the half clamp.
3. If necessary, adjust the footplates to the necessary
angle and depth for the user. Refer to the following
sections of this procedure.
Adjustable Angle Flip-up Footplate Depth
Adjustment (FIGURE 7)
1. Remove the two (2) flat bolts, washers and locknuts
that secure the adjustable angle flip-up footplate to
the footplate hinge.
NOTE: Observe the angle of the articulating footplate
for reinstallation.
2. Move the adjustable angle flip-up footplate to one
(1) of four (4) mounting positions.
3. Retighten the two (2) flat bolts, washers and lock-
nuts.
NOTE: The settings for positioning the adjustable
angle flip-up footplates on the half-clamps may vary
for each footplate.
Adjustable Angle Flip-up Footplate Angle
Adjustment (FIGURES 7 AND 8)
1. Loosen, but do not remove the two (2) flat bolts and
locknuts that secure the adjustable angle flip-up
footplate to the footplate hinge.
2. Position the adjustable angle flip-up footplate to the
necessary angle to accommodate the user.
3. Retighten the two (2) flat bolts and locknuts.
PROCEDURE 1 FRONT RIGGINGS
F
R
O
N
T
R
I
G
G
I
N
G
S
FIGURE 7 - INSTALLING ADJUSTABLE ANGLE
FLIP-UP FOOTPLATES
Nylon
Adjustment
Screw
Half
Clamp
Washers
90
o
Footrest Support
Adjustable
Angle Flip-Up
Footplate
Footplate Hinge
Flat Bolts
Half
Clamp
Footplate Hinge Locknuts
FIGURE 9 - ADJUSTABLE ANGLE FLIP-UP
FOOTPLATE PERPENDICULAR AND/OR
INVERSION/EVERSION ADJUSTMENT
Half Clamp
Adjustable
Angle Flip-Up
Footplate
Looking From the Front
Towards the Rear of
the Wheelchair
Adjustable Angle Flip-up Footplate
Perpendicular and/or Inversion/Eversion
Adjustment (FIGURES 7 AND 9)
NOTE: It is not necessary to remove the footplate
to perform this adjustment.
1. Insert a flathead screwdriver through the half
clamp on the adjustable angle flip-up footplate.
2. Slowly turn the nylon adjustment screw in or out
until the adjustable angle flip-up footplate is per-
pendicular to the footrest assembly or the desired
inversion/eversion is obtained.
FIGURE 8 - ADJUSTABLE ANGLE FLIP-UP
FOOTPLATE ANGLE ADJUSTMENT
Adjustable
Angle Flip-up
Footplate
Looking From
Inside Towards
the Outside of the
Wheelchair.
Footplate Hinge