Icom IC-2200H - Manual (Page 8)

SECTION 3 OPTIONAL UNIT INSTALLATION
3 - 1
➀
Remove [DIAL] and unscrew the 2 allen-socket bolts from
the front panel using with an allen wrench (2.5 mm;
1 ⁄ 10
″).
NOTE: When attaching the front panel to the main unit,
make sure the flat cable are running in the groove to pre-
vent catching between front panel and main unit.
➅
Return the front panel and the allen-socket bolts to their
original position.
➂
Attach the insulation sheet (supplied as accessory) to IC
on the Front unit.
➃
Remove the protective paper attached to the bottom of
the optional unit to expose the adhesive strip.
➁
Detach the front panel from the main unit.
➄
Intall the unit as illustrated below. Insert tightly to avoid
bad contact.
Allen-socket
bolts
Insulation sheet
Flat cable