Iluv i199 - Manual (Page 17)

Stereo Audio System for Your iPod V11M11_IM_EN_01122007
www.i-Luv.com - 16 -
OPERATIONAL INSTRUCTIONS
Using the Alarm Function –Continued
2.
To activate or deactivate the alarm, press the ALARM 1 or ALARM 2 button once.
Notes: To preview alarm setting, the alarm must be activated before pressing Wake To Button.
3.
To snooze, press the SNOOZE / DIMMER button on the i199, following the sounding of the alarm. The alarm will then shut off and will sound again in
approximately 9 minutes. You will have the opportunity to repeat this cycle many times during a 1 hour allotted alarm cycle.
4. To turn the alarm off, press the POWER button on the i199 (or the POWER button on the Remote Control). If all settings remain the same, the alarm
will turn on the following day at the same time. When the alarm is not turned off after it sounds, it will then play for approximately 60 minutes and turns
off automatically. This cycle will repeat every 24 hours unless the controls are changed.
5. To prevent the alarm from coming on daily, press the ALARM 1 or ALARM 2 buttons and set to off. The Alarm Icon will disappear.
Notes on Alarm Function:
•
Set your iPod to the repeat mode if you’ve selected Wake to iPod, and your iPod has less than one hour of songs.
• If you have selected the Wake To iPod, CD or USB setting, yet no iPod, CD or USB is present at the alarm time, the i199 will automatically switch to
the BUZZER mode.
• In the event of a power outage or if AC power is disconnected, when the i199 is powered by the Backup Battery, the alarm will NOT sound and time
and date will not be displayed. Time and date settings, however, will be temporarily saved.
• All alarm functions will be activated in standby mode, if you already turned on the i199, alarm function will be deactivated.
Adjusting the Brightness of LCD Screen
To adjust the brightness of the LCD screen, press the SNOOZE / DIMMER button on the unit during normal or standby mode. Each press will change the
brightness level of the LCD screen.