InFocus 620 User Manual
Page 46
42
M
a
i
n
t
e
n
a
n
c
e
&
T
r
o
u
b
l
e
s
h
o
o
t
i
n
g
•
Using a small, flat-blade screw driver, remove the two
screws on the bottom of the projector on the outside of the
lamp module cover.
CAUTION: Never operate the
projector with the lamp cover open
or removed. This disrupts the air
flow and causes the projector to
overheat.
•
Pull the lamp cover up and remove it.
F
IGURE
35
Removing the lamp module cover
CAUTION: Be sure to replace
the projection bulb as soon as
possible after the lamp monitor
light comes on. If the lamp
remains in use too long, there is a
danger of lamp explosion. If this
happens, your LitePro will be
severely damaged.
4
Remove the lamp module.
•
Lift the ring of the screw fastener up and turn it 1/4 turn
counterclockwise (the screw remains attached to the lamp
module).
F
IGURE
36
Turning the ring of the screw fastener