InFocus 620 User Manual

Page 52

Advertising
background image

48

M

a

i

n

t

e

n

a

n

c

e

&

T

r

o

u

b

l

e

s

h

o

o

t

i

n

g

3

Verify that the Desktop area is set to 800x600 or less, pref-
erably 640x480.

Also check the following:

•

Does your computer have a compatible graphics board? The
projectors aren’t CGA or EGA compatible.

•

Is your computer’s graphics board turned on? This is especially
true for laptop computers. See “Portable and Laptop Activa-
tion Chart” on page 55.

Problem: Image is too wide or narrow for screen
•

You might need to manually adjust the tracking to reduce or
enlarge the projected image. Refer to “Manual Tracking” on
page 38.

•

Adjust the resolution of your monitor if it’s greater than
800x600 for the 610 or 1024x768 for the 620. Only these resolu-
tions at 60 Hz or less display on the projector.

•

Make sure that your computer has a compatible graphics
board. The projector is not compatible with CGA, EGA, or
1280x1024 graphics modes.

Problem: Image is out of focus
•

Turn the projection lens to focus the image.

•

Make sure the projection screen is at least 5 feet from the pro-
jector.

•

Check the projection lens to see if it needs cleaning.

Problem: Image and menus are reversed left to right
•

The rear projection mode is probably set. Switch back to for-
ward projection from the Controls menu. The image should
immediately return to forward projection. See “Rear Projec-
tion” on page 40.

Problem: Image and menus are upside down
•

Ceiling mode is probably set. Turn off the mode from the Con-
trols menu. The image should immediately return to forward
projection. See “Ceiling” on page 39.

Advertising