IBM Oce TDS400 - Manual (Page 164)

164 Océ TDS400 User Manual
Maintenance of the reinforcement unit
This section covers maintenance activities for the optional reinforcement unit
of the folder, such as:
■ Insert a new tape roll
■ Empty the waste box
■
Clean the reinforcement knives
Attention: To avoid damage to the reinforcement unit, only use the original
reinforcement strips from Océ.
Insert a new tape roll
When the tape roll is empty while the printer is in stand-by, the following
message will appear on the display: ‘RU tape empty’. Open the reinforcement
unit and replace the empty tape roll.
▼ How to remove an empty tape roll
1 Open the side door of the reinforcement unit (see Figure 73).
[73] Opening the side door of the reinforcement unit
2 Turn the two guide plates away from the pin roller and lock them into their
open position (see Figure 74).