Invacare IIBASIC - Manual (Page 25)

25
F
R
O
N
T
R
I
G
G
I
N
G
S
PROCEDURE 3 FRONT RIGGINGS
FWD WHEELCHAIRS ONLY
ADJUSTING FOOTBOARD MOUNTING
BRACKET ANGLE - FWD MODELS ONLY
(FIGURE 10).
NOTE: This procedure applies to FWD wheelchair mod-
els only.
NOTE: Angle availability is limited when the motors
are in the forward-most position.
1. Remove the caplug cap.
2. Remove the front hex screw and caplug washer that
secure the footboard mounting bracket and bushing
to the wheelchair.
3. Repeat STEPS 1-2 for the opposite footboard mount-
ing bracket.
4. Move the footboard mounting brackets to one (1) of
three (3) positions.
NOTE: To ensure the existing hex screws tighten securely,
apply Loctite 242 onto the threads.
5. Reinstall the two (2) hex screws and caplug washers
through the two (2) footboard mounting brackets and
bushings and into the wheelchair.
6. Torque the two (2) hex screws to 13-ft/lbs.
7. Reinstall the two (2) caplug caps.
FIGURE 10 - ADJUSTING
REMOVABLE FOOTBOARD - ADJUSTING
FOOTBOARD MOUNTING BRACKET ANGLE
Bushing
Footboard
Pivot
Assemblies
Front Hex
Screw
Caplug
Cap
Caplug
Washer
Battery
Tray
3 Mounting
Positions
Footboard
Mounting
Bracket
ADJUSTING THE REMOVABLE
FOOTBOARD HEIGHT (FIGURE 11)
1. Remove the removable footboard plate. Refer to
REMOVING/INSTALLING THE REMOVABLE
FOOTBOARD ONTO/FROM THE WHEELCHAIR
in PROCEDURE 3 of the Owner’s Manual.
2. Remove the caplug cap.
3. Remove the mounting screw, caplug washer, flat
washer and nut that secures the two (2) large wash-
ers and support tube to the height adjustment
bracket and footboard bracket. Refer to DETAIL
“A”.
4. Remove the nut, flat washer and that secure the
threaded arm on the height adjustment bracket to
the footboard bracket. Refer to DETAIL “B”.
5. Perform one (1) of the following:
A. MWD WHEELCHAIRS - Move the height ad-
justment bracket to one (1) of seven (7) height
positions.
B. FWD WHEELCHAIRS - Move the height ad-
justment bracket to one (1) of five (5) height
positions.
6. Reinstall the flat washer and nut that secures the
threaded arm on the height adjustment bracket to
the footboard bracket. Refer to DETAIL “B”.
7. Reinstall the mounting screw, caplug washer, flat
washer and nut that secures the two (2) large wash-
ers and support tube to the height adjustment
bracket and footboard bracket. Refer to DETAIL
“A”.
8. Reinstall the caplug caps.
9. Repeat STEPS 2-8 for the opposite footboard
bracket.
10. Reinstall the removable footboard plate. Refer to
REMOVING/INSTALLING THE REMOVABLE
FOOTBOARD ONTO/FROM THE WHEELCHAIR
in PROCEDURE 3 of the Owner’s Manual.