Invacare IIBASIC - Manual (Page 52)

52
BATTERY TRAY
WARNING
Pinch point exists between battery tray and bat-
tery bracket.
Folding Battery Tray for Transport (FIGURE 7)
1. If necessary, remove the front shroud. Refer to REMOV-
ING/INSTALLING SHROUDS - FWD WHEELCHAIRS
in PROCEDURE 9 of this manual.
2. Remove the battery boxes from the wheelchair. Refer
to INSTALLING/REMOVING BATTERY BOXES in this
procedure of the manual.
3. Perform one (1) of the following:
A. FOR RANGER II
BASIC
and RANGER II
STANDARD
-
Lift up on the pin side of the battery tray and rotate
UP towards the battery tray pivot.
B. FOR RANGER II
JR
- Lift up on the notched side of
the battery tray and rotate UP towards the battery
tray pivot.
4. Fold the wheelchair. Refer to TRANSPORTING
RANGER II FWD in this procedure of the manual.
Unfolding Battery Tray for Use (FIGURE 8)
1. Unfold the wheelchair. Refer to TRANSPORTING
RANGER II FWD in this procedure of the manual.
2. Perform one (1) of the following:
A. FOR RANGER II
BASIC
and RANGER II
STANDARD
-
WARNING
Make sure pins of battery tray are secure in
the mounting slots of the hanger bracket,
otherwise injury or damage may result.
Rotate the pin side of the battery tray DOWN against
the mounting slots on the hanger bracket.
B. FOR RANGER II
JR
- Rotate the notched side of
the battery tray and DOWN against the battery
tray stop.
3. Install the battery boxes. Refer to INSTALLING/REMOV-
ING BATTERY BOXES in this procedure of the manual.
4. If necessary install the front shroud. Refer to REMOV-
ING/INSTALLING SHROUDS - FWD WHEELCHAIRS
in PROCEDURE 9 of this manual.
Rear Shroud
Rear
Battery
Box
Slot
DETAIL "A"
Retaining
Strap
Joystick
Cable
Tie-Wrap
Retaining
Strap
Rear Battery
Box
Pull this end of
retaining strap to
secure battery
box in place
Front
Battery
Box
Retaining
Strap
Front
Shroud
Battery
Connections
on Side of
Wheelchair
Frame
FIGURE 6 - INSTALLING/REMOVING BATTERY BOXES
RANGER II
JR
Battery
Tray
PROCEDURE 11 FWD WHEELCHAIRS
F
W
D
W
H
E
E
L
C
H
A
I
R
S