Intermec NORAND 600 - Manual (Page 16)

SECTION 1 General Information
1-10 NORAND R 600 Series Industrial Mobile Computer User’s Guide
"
The 600 Series Single/Vehicle Dock provides a stan-
dard PC compatible DB-9 (male) serial port.
"
The 600 Series Multidock converts the signals from
the computer’s RS-232 serial port to RS-485 and
brings out an RS-485 bus to two DB-9 female connec-
tors compatible with Norand RS-485 networking.
Resetting
In the rare event that your Industrial Mobile Computer
fails to respond to your input, it may be necessary to
“reset.” To reset press the [Gold], [Esc], and [0] keys at the
same time, hold the keys down for three seconds, and your
computer will reboot. Resetting takes you to the start up
screen.
Figure 1-5
Resetting your Computer
Reset keys
Customer Response Center and Product
Service
Factory Service
If your unit is faulty, you can ship it to your nearest
authorized Service Center for factory-quality service. The
address and telephone number are included on the Product
Service Information Card shipped with your product.