Back, Front, Speaker installation – Iiyama L403W User Manual
Page 8: Procedure and conditions for monitor installation
Turn off the power switch and unplug the monitor before installation to avoid electric shock or damage.
The speaker is heavy. Two person handling is recommended.
Install the speaker on a stable surface. The monitor or the speaker may cause injury or damage if they fall or are dropped.
Do not give a strong impact to the monitor or speaker. It may cause damage.
Do not push mesh area of speaker strongly to avoid denting it.
Remove the Speaker by using the procedure above in reverse.
A Ensure that both the computer and the monitor are switched off.
B Fasten the Bracket to the Speaker with the Screws.
C Fit the screw holes of the Bracket to the cavities on the back of the monitor (4 cavities for each side)
and then tighten the Screws to fasten the Speaker.
Do not misplace the right and left speakers. Install the speakers with bass reflex port down.
D Insert the Speaker Cable into the Speaker Input Terminal and Output Terminal.
When connect the Speaker Cable, conform the color of the Speaker Cable and Speaker
Terminal. If the cables are connected incorrectly the sound quality will be reduced.
6 BEFORE YOU OPERATE THE MONITOR
A Environmental temperature and humidity for installation:
Please be sure that an environmental temperature and humidity DO NOT exceed the range described in the page 15 SPECIFICATIONS.
B Size of screw
n Length: After fasten the bracket with screws, the length of screw in the monitor
should be more than 10-15mm.
n Position: more than 6 points
C Recommended supportive device:
For the details of installation, see the manual of your supportive device.
Name: OBR (FFP-IN00-X)
Follow the instructions below when installing the monitor to the wall.
Screw × 6
PROCEDURE AND CONDITIONS FOR MONITOR INSTALLATION
Unplug the monitor before installation to avoid electric shock or damage.
The monitor is heavy. Two person handling is recommended.
Do not give a strong impact to the monitor. It may cause damage.