Back, Connecting your monitor, Computer setting – Iiyama L403W User Manual
A Ensure that both the computer and the monitor are switched off.
B Connect the computer to the monitor with the signal cable. (See page 16 for CONNECTOR PIN ASSIGNMENT.)
C Connect the monitor to the audio equipment with the Audio Cable for computer when using the audio features.
D Connect the Power Cable to the monitor first and then to the power supply.
n For connection to Macintosh computers, an adapter may be needed. Please contact your dealer for this.
n Make sure you tighten the finger screws at each end of the signal cable.
[Example of Connection]
The signal cables used for connecting the computer and monitor may vary with the type of computer used. An incorrect
connection may cause serious damage to both the monitor and the computer.
Turn off the power switch and unplug the monitor and peripherals before connection to avoid electric shock or damage.
CONNECTING YOUR MONITOR
BEFORE YOU OPERATE THE MONITOR 7
n Signal Timing
Change to the desired signal timings listed on page 16 in COMPLIANT TIMING, after you confirm that the picture appears normally.
n Windows 95/98/2000/Me/XP Plug & Play
The iiyama LCD monitor complies with DDC2B of VESA standard. The Plug & Play function runs on Windows 95/98/2000/Me/XP by
connecting the monitor to DDC2B compliant computer with the Signal Cable supplied. Windows 95/98/2000/Me/XP Monitor Information File
for iiyama monitors may be necessary for your computer and obtained via the Internet, using the address:
n For additional information on how to download the driver for your monitor, please access one of the internet sites noted
n Monitor Drivers are not required in most cases for Macintosh or Unix operating systems. For further information, please
contact your computer dealer first for advice.
Power Cable (Accessory)
DVI-A Signal Cable DV69 (Accessory) or
DVI-D Signal Cable DV66 (Accessory)
Audio Cable AD27 for computer (Accessory)
D-Sub connector of computer
DVI connector of computer
Tuner / Video Adapter
OTA3-2PS or OTA3-2PSB