Intermec F4 - Manual (Page 45)

Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 3 44
Chapter 7 Setup Mode
Setup Mode Overview, Part 2
Continued from previous page
Continued on the next page if an EasyLAN 100i interface board is installed.
SETUP:
TEST/SERVICE TEST/SERVICE:
TESTPRINT TESTPRINT:
CONFIG
TEST/SERVICE:
DATA DUMP
YES
DATA DUMP:
NO
TEST/SERVICE:
LABEL REST DOTS LABEL REST DOTS:
[0]:
TEST/SERVICE:
FORM ADJ DOTS X FORM ADJ DOTS X:
[0]:
TEST/SERVICE:
FORM ADJ DOTS Y FORM ADJ DOTS Y:
[0]:
SETUP:
MEDIA
CONTINUOUS
MARK
MEDIA:
MEDIA TYPE MEDIA TYPE:
GAP
TTR
MEDIA:
PAPER TYPE PAPER TYPE:
DT
MEDIA:
LABEL LENGTH LABEL LENGTH:
[1200]:
MEDIA:
SENSITIVITY SENSITIVITY:
[420]:
MEDIA:
DARKNESS DARKNESS:
[0]:
CONFIGURATION
TEST/SERVICE:
MEMORY RESET MEMORY RESET:
ALL
HW
CONFIG:
SW
TESTPRINT:
FORMAT
SELECT
FORMAT:
ALL
SELECT:
[0]:
TESTPRINT:
PAGE
SELECT
PAGE:
ALL
SELECT:
[0]:
TESTPRINT:
UDC
SELECT
UDC:
ALL
SELECT:
[0]:
TESTPRINT:
FONT
SELECT
FONT:
ALL
SELECT:
[0]: