IBM Switch 9077 - Manual (Page 114)

Installation and Configuration 96
Nevertheless, check the file /etc/grdev1.conf. It must contain an entry for the
slot in which the media card is installed. As we have our card in slot 3, the
entry looks as follows:
These entries show up after the SP Switch Router Adapter card gets
configured on the SP Switch.
3.13 Step 5. Reset SP Switch Router System to Install Files
To install the system configuration files, first save the files and then reboot the
SP Switch Router.
Save the files after you complete changing the system parameters, and again
after you configure the media cards and any network services, such as
filtering or dynamic routing, using
grwrite -v. To check if any files need to be
written to permanent storage, use grwrite -vn .
Note: grwrite only saves files in the /etc directory. If you changed files in
different directories, use grsite and grsite --perm, respectively.
Use reboot -i to reset the system.
3.13.1 Saving Configuration Files
Use the grwrite -v command to save the configuration files in the /etc
directory from RAM to a flash device. This preserves the configuration files
over a reboot.
# CARD 3 Interface 0
#
2.21.4.1.1.1 "03" # Node Name
2.21.4.1.1.2 4 # Node Number
2.21.4.1.1.3 "00:00:00:01:00:00:00:06:00:01" # Switch Token
2.21.4.1.1.4 2 # Switch ARP
2.21.4.1.1.5 3 # Switch Node Number
2.21.4.1.1.6 x192.168.14.4 # IP Address
2.21.4.1.1.7 x255.255.255.0 # Net Mask
2.21.4.1.1.8 1024 # Max Link Pckt Len.(bytes)
2.21.4.1.1.9 1 # IP Host Offset
2.21.4.1.1.10 1 # Configuration State
2.21.4.1.1.11 sp21en0 # System Name
2.21.4.1.1.12 2 # Node State
2.21.4.1.1.13 1 # Switch Chip Link
2.21.4.1.1.14 31 # Node Delay
2.21.4.1.1.15 1 # Admin Status
#