IBM Switch 9077 - Manual (Page 208)

190 IBM 9077 SP Switch Router: Get Connected to the SP Switch
5.2.2 Complex Configuration
In this section, we describe the setup of a complete scenario with a dual SP
Switch Router connection, and explain why node 8 in SP21 in this setup is
able to route IP traffic via IP address 192.168.14.129 (Figure 60 and Table 20
on page 191), although the way back apparently does not exist.
Figure 60. Configuration with Dual SP Switch Router - SP Switch Connection
Configuration assumptions:
• SP Switch Router Adapter cards were installed according to Section 3.7,
“Step-by-Step Media Card Configuration” on page 86 and Section 5.2.1,
“Configuration of a Dual SP Switch Router Connection” on page 187, and
both work properly.
• ARP should be enabled on the SP Switch network to provide the most
flexibility in assigning IP Addresses (strongly recommended!).
• The HIPPI connection is correctly installed and works (refer to Section 7.3,
“HIPPI Backbone Connection” on page 227). We do not care about HIPPI
connections in this chapter.
• All routes on the SP Switch Routers are assumed to be set correctly.
Table 20 on page 191 shows the IP addresses used in our configuration.
GRF 1600
SP
Sw
it
c
h
SP Switch Router
Adapter card 1 - gt030
Node 10
Node 8
Node 6
SP21
HIPPI
GRF 400
S
P
S
w
it
c
h
SP Switch Router
Adapter card 3
SP2
HIPPI
Node1
SP Switch Router
Adapter card 2 - gt050