IBM Switch 9077 - Manual (Page 65)

Router Node 47
2.4.2.3 The endefadapter Command
The
endefadapter command is used to add or change the extension node
adapter IP information in the SDR DependentAdapter object, and can be
executed using
smit . The fast path for smit is enter_extadapter . The command
options are shown in Table 9.
Table 9. endefadapter Command Options
2.4.2.4 The enrmadapter Command
The
enrmadapter command is used to remove the SDR DependentAdapter
object, and can also be executed using smit. The fast path for smit is
delete_extadapter .
Flags SMIT Option Description
-a Network
address Specifies the IP address of the extension node.
-m Network
netmask Specifies the netmask for the extension node.
-r Reconfigure
the extension
node Specifies if the enadmin command is to be
activated after the endefadapter command
completes. With this option, the user does not
have to explicitly issue the
enadmin command. If
the specification is yes , the -r option is part of the
command. If the specification is no , the -r option
is not part of the command.
Node number This is the node number the extension node
logically occupies in the RS/6000 SP.
Note that this command only affects the SDR, unless the -r option is
issued. The -r option should be issued only if the endefnode has been
executed for the extension node.
When the GRF is properly configured and powered on, with the SP Switch
Router Adapter inside, it periodically polls the Control Workstation for
configuration data. The
-r option or enadmin command is not required to
activate the polling here.
Attention