IBM C2B 2.25 Brick On Sled carrier 128-pin HPC - Manual (Page 17)

USER RESPONSIBLE F O R V E R I F Y I N G VERSION A N D COMPLETENESS
O E M F U N C T I O N A L SPECIFICATION ULTRASTAR X P (DFHC) SSA M O D E L S 1.12/2.25 GB - 1.0" H I G H
Example 4. Calculate the 12 volt peak current.
To compute the sum of the 12 volt peak currents the following is done.
mean
+ 1 2 V D C (idle avg) 0.28 amps
+ 1 2 V D C (seek peak) 1.2 amps
TOTAL 1.48 amps
Example 5. Calculate the mean plus 3 sigma 12 volt peak current.
To compute the sum of the 12 volt peak current's 1 sigma value assume all distributions are normal. There-
fore the square root of the sum of the squares calculation applies.
sigma
+ 1 2 V D C (idle avg) 0.02 amps
+ 1 2 V D C (seek peak) 0.02 amps
TOTAL sqrt((0.02)**2+(0.02)**2)=0.028 amps
So the mean plus 3 sigma peak current is 1.48 + 3*0.028 = 1.56 amps
Things to check when measuring 12 V supply current:
Null the current probe frequently. Be sure to let it warm up.
Adjust the power supply to 12.00 V at the drive terminals.
Use a proper window width, covering an integral number of spindle revolutions.
Measure values at 25 degree C casting temperature.
Get a reliable trigger for Seek Peak readings.
Source filename=POWER IBM Corporation Page 17 of 87