IBM C2B 2.25 Brick On Sled carrier 128-pin HPC - Manual (Page 35)

USER RESPONSIBLE F O R V E R I F Y I N G VERSION A N D COMPLETENESS
O E M F U N C T I O N A L SPECIFICATION ULTRASTAR X P (DFHC) SSA M O D E L S 1.12/2.25 GB - 1.0" H I G H
Hot plugging the SSA link will be recognized by the next node which will cause a configuration process to
be started by the Initiators.
During hot plugging, the supplies must not go over the upper voltage limit. This means that proper ESD
protection must be used during the plugging event.
During hot un-plugging if the operating shock limit specification can be exceeded then the drive should be
issued a Start/Stop Unit command (spin down) that is allowed to complete before un-plugging.
Source filename=POWER IBM Corporation Page 35 of 87