IBM 3590 - Manual (Page 46)

Table 5. Operator Messages (continued)
Message Operator Response
MAGAZINE EXPORT
ER
Operator action required:
When the tape subsystem placed a cartridge in the magazine, the
cartridge was placed either beyond or in front of the Export position.
When the cartridge is not in the true Export position, it is possible that
a cartridge placed in front of the Export position may unexpectedly be
reused. When a cartridge is placed beyond the Export position, and
not in the true Export position, it is possible that the cartridge will not
be detected in the magazine.
Correct either of these conditions by removing the magazine from the
ACF, checking that all cartridges are correctly positioned, and replace
the magazine into the ACF.
MAGAZINE FULL
Operator action required:
Empty the magazine or replace it with another magazine.
MAGAZINE LOCKED
Operator action required:
Same as UNLOCK MAGAZINE.
MOVE ERROR
Service representative intervention may be required.
Operator action required:
Ensure that the cartridge is not damaged or broken and that the
cartridge is a 3590 cartridge. See “Damaged Cartridges” on page 87.
An error occurred in the ACF. Check the message display and report
any FID codes to your service representative.
In certain modes, operations may continue by using the priority cell.
NO CARTRIDGE
Operator intervention or possible service representative corrective
action required.
Operator action required:
The tape subsystem detects the presence of cartridges but cannot find a
cartridge in either the magazine or the priority cell. Check the position
of all the cartridges to ensure they are properly positioned in the
magazine and the priority cell. Press Start. If this condition is not
cleared, remove and replace the magazine in the ACF. If the condition
persists or a FID message is displayed, report any FID codes to your
service representative.
26 3590 Operator Guide