Integra DTR-8.8 - Manual (Page 123)

123
Net/USB —Continued
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Mac Address
This is the AV receiver’s MAC (Media Access Control)
address. This address cannot be changed.
Control
This setting enables or disables control over the network.
Enable: Control over the network enabled.
Disable: Control over the network disabled.
■ Port
This is the network port used for control over the net-
work.
DHCP
This setting determines whether or not the AV receiver
uses DHCP to automatically configure its IP Address,
Subnet Mask, Gateway, and DNS Server settings.
Enable: DHCP enabled.
Disable: DHCP disabled.
If you select Disable, you must configure the IP Address,
Subnet Mask, Gateway, and DNS Server settings your-
self.
IP Address
If you set the DHCP setting to Disable, you must specify
an IP address. Enter a static IP address provided by your
ISP.
The IP address must be within the following ranges.
Class A: 10.0.0.0 to 10.255.255.255
Class B: 172.16.0.0 to 172.31.255.255
Class C: 192.168.0.0 to 192.168.255.255
Most routers use Class C IP addresses.
Subnet Mask
If you set the DHCP setting to Disable, you must specify
a subnet mask address.
Enter the subnet mask address provided by your ISP
(typically: 255.255.255.0).
Gateway
If you set the DHCP setting to Disable, you must specify
a gateway address.
Enter the gateway address provided by your ISP.
DNS Server
If you set the DHCP setting to Disable, you must specify
a DNS server.
Enter the DNS server addresses provided by your ISP.
Proxy URL
To use a Web proxy, enter its URL here.
Proxy Port
If you’re using a Web proxy, enter a proxy port number
here.
3 Use the Up and Down [ ]/[ ]
buttons to select “6. Network,”
and then press [Enter].
The Network screen appears.
4 Use the Up and Down [ ]/[ ]
buttons to select the settings,
and use the Left and Right
[
]/[ ] buttons to set them.
To enter an IP address, select the set-
ting, and then press [Enter]. The arrow
[
]/[ ]/[ ]/[ ] buttons can then be
used to enter numbers. Press [Enter]
again to set the number.
The settings are explained below.
5 When you’ve finished, use the Up
and Down [
]/[ ] buttons to
select “Save Settings,” and then
press [Enter].
6 When you’ve finished, press the
[Setup] button.
Setup closes.
Enter
Enter
7-6.Network
MAC Adress 00:00:00-00:00:00
Control Disable
Port ---
Enter
Enter
Enter
7-6.Network
Proxy Enable
Proxy URL
Proxy Port 8080
Save Settings
Setu
p