Integra DTR-8.8 - Manual (Page 127)

127
Zone 2 and Zone 3 —Continued
If you’ve connected your Zone 2 or Zone 3 speakers to
an amp with no volume control, set the Zone 2 Out or
Zone 3 Out setting, respectively, to Variable so that you
can set the zone’s volume, balance, and tone on the AV
receiver.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
This section explains how to use Zone 2 and Zone 3.
Zone 2/Zone 3 Out Settings
1 Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [Enter].
The Hardware Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “2. Zone 2/
Zone 3,” and then press [Enter].
The Zone 2/Zone 3 screen appears.
4 Use the Up and Down [ ]/[ ]
buttons to select “Zone 2 Out” or
“Zone 3 Out,” and use the Left
and Right [
]/[ ] buttons to
select:
Fixed: The Zone 2 or Zone 3 volume
must be set on the amp in that
zone.
Variable: The Zone 2 or Zone 3 vol-
ume can be set on the AV
receiver.
Receiver
Setu
p
Enter
Enter
Enter
Enter
7-2.Zone2/Zone3
Powered Zone2 Not Act
Zone2 Out Fixed
Zone3 Out Fixed
Enter
Enter
5 Press the [Setup] button.
Setup closes.
Using Zone 2 and Zone 3
Setu
p
Zone 3
Zone 2
Tone
Off Level ,
+
-
On Standby
TV
Input
TV CH
TV VOL
--/--- 10 11 12
D.TUN
+10 0 Clear
1 2 3
4 5 6
7 8 9
Input Selector
VCR/DVR CBL/SAT DVD
Tape Tuner CD
Phono Net/USB
Game/TV
Macro
1 2 3
VCR DVD
CDR/MD/Dock
CD Zone 2
Remote Mode
Dimmer
Tape/AMP
Sleep
Receiver TV Net/USB Cable
VOL
CH
Disc
Album
+
-
Enter
Top Men u Men
u
Display Muting
Exi t Gu ide
Prev
CH Ret urn Setu
p
RC- 688M
Audio Repeat Play Mode
Open/Close
Listening Mode
DVD HDD
Playlist Random Rec
Test Tone CH Sel
Direct
Stereo
Level+ Level-
L Night Audio Sel
THX All ST
Re-EQ
Subtitle
Video Off
VCR
Surround
SAT
Zone 3
AUX 1 AUX 2
Zone3
Zone2
Muting
On
Standby
Level–,
Level+
Input
Selector