Icom IF6061 - Manual (Page 9)

6
1
PANEL DESCRIPTION
1 TX CODE ENTER KEY (PMR or BIIS PMR operation only)
Push to enter the ID code edit mode directly, for both 5-tone
and MSK. Then set the desired digit using [CH Up]/
[CH Down]. (p. 11)
TX CODE CHANNEL SELECT KEY
➥ Push to enter the ID code channel selection mode directly.
Then set the desired channel using [CH Up]/[CH Down].
(p. 10)
➥ During ID code channel selection mode, push for 1 sec. to
enter the ID code edit mode for 5-tone and MSK. Then set
the desired digit using [CH Up]/[CH Down]. (p. 11)
TX CODE CHANNEL UP/DOWN KEYS
➥ Push to select a TX code channel directly.
➥ Push to set the desired digit during the ID code edit mode.
ID-MR SELECT KEY (PMR or BIIS PMR operation only)
➥ Recalls detected ID codes.
• Push this key, then select the ID code using [CH Up]/[CH Down].
• Up to 5 ID’s are memorized.
➥ Push and hold for 1 sec. to erase the selected ID’s.
HOOK SCAN KEY
When the on hook scan function is activated, push this key
to disables on hook scan function (stop scanning) temporari-
ly. Push this key again to re-start scanning.
USER SET MODE KEY
➥ Push and hold to enter user set mode.
• During user set mode, push this key to select an item, and
change the value or condition using push [CH Up]/[CH Down].
➥ Push and hold this key again to exit user set mode.
User set mode is also available via the ‘Power ON function.’
Refer to p. 14 also.
MR-CH ENT KEYS
Push to enter the memory channel selection mode, then enter
the desired channel number using the 10-keypad of the con-
nected microphone.
OPT 1/2/3 KEYS
Push to control the output signal level from the optional unit
connector.
IC-F5061_F6061_0.qxd 07.4.9 0:59 PM Page 6 (1,1)