InSciTek Microsystems 9102 - Manual (Page 21)

635 Crosskeys Office Park • Fairport, NY 14450 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2004 InSciTek Microsystems, Inc. All rights reserved. Allworx is a registered trademark of InSciTek Microsystems. All other names may be trademarks or registered trademarks
of their respective owners.
17
Adjusting Your Phone
Volume
You can adjust the volume of the incoming ring, handset speaker, the speakerphone, and
the headset. The volume will be adjusted for the device that are currently using.
To adjust the volume:
1. You can adjust the incoming ring when a call comes in. To adjust other volumes,
pick up the handset, turn on the speakerphone, or headset.
2. The screen shows the device for which you are adjusting the volume.
3. Press Volume Bar on the right to increase the volume.
4. Press Volume Bar on the left to decrease the volume.
Change the labels for lines
Make sure you keep your lines labeled correctly (this is only available on the Allworx
9112 phone). To change a label, remove the paper from beneath the plastic label cover,
update the numbers, and replace it under the cover. A word template can be obtained at
our website (www.allworx.com).
Adjust the angle of the phone
You can adjust the phone on its base so that it’s easy to use and easy to read the screen.
1. Grasp the phone and the base separately.
2. Press the locking tab on the base.
3. Tilt the phone up or back in its base.
Adjust the contrast of the screen
You can change the contrast of the screen to make it easily readable for you. To do this:
1. Select the softkey for CONFIG.
2. Use the arrow buttons to scroll to Preferences and press Select.
3. Select LCD Contrast.
4. Use the Volume Bar or Up / Down arrow buttons to increase or decrease the
contrast.
5. Press Select to save the contrast setting.