InSciTek Microsystems 9102 - Manual (Page 5)

635 Crosskeys Office Park • Fairport, NY 14450 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2004 InSciTek Microsystems, Inc. All rights reserved. Allworx is a registered trademark of InSciTek Microsystems. All other names may be trademarks or registered trademarks
of their respective owners.
1
Congratulations! You’re the new owner of an Allworx 9102 or 9112 VoIP phone.
This phone will make it easy for you to place and receive calls when using the
Allworx 10x system.
Getting Started
What is in the box?
Check out the contents of the box your phone came in. You should have:
•
Allworx 9102 or 9112 phone (including base)
•
Power supply
•
Handset with cord
•
This guide
You will also need:
•
Ethernet cable to connect the phone to the network
Connecting the Phone
We’ve taken all the challenge out of connecting your phone properly. Follow these steps
to connect:
1. Plug one end of the Ethernet cable into the Network jack on the back of the
phone. Plug the other end into your Ethernet jack on the wall. WARNING: DO
NOT CONNECT TO AN ANALOG PHONE LINE.
2. The phone contains an Ethernet switch. A computer can be connected to the
network thru the phones PC port.
3. If you’re using Power over Ethernet (PoE), the power to the phone was supplied
when you connected the Ethernet cable. Skip this step.
If you’re not using PoE, connect the power cable into the phone, then plug the
other end into an outlet. It’s a good idea to use a surge suppressor.
4. After applying power, the phone will initialize itself. You can watch its progress on
the phone’s screen and a normal sequence would include:
a. Allworx Logo appears.
b. Starting network.
c. Loading configuration files.
d. Station Init complete.
e. After successful startup, the phone will display date, time, your user
name etc.
f. If the phone does not follow this sequence or displays an error, contact
your system administrator.