IBM Oce TDS800 - Manual (Page 210)

210 Océ TDS800 User Manual
8 Clean the upper and lower knife with Cleaner K (see Figure 121).
[121] Clean the upper and lower knife
9 Oil the felt with Fixing Unit Cleaning Oil (silicon oil).
[122] Oil the felt
10 Close the side door of the reinforcement unit.
The knives are placed back in its home position. The picture on the display
disappears. The message ‘Press start to resume job’ or ‘Ready to print’ appears
depending if a job was interrupted to clean the knives.
11 The yellow indicator goes OFF.