IBM Oce TDS800 - Manual (Page 61)

Using the Océ TDS800 to Copy 61
Define settings for the next original
You can define the settings for each original you want to copy. When
‘Automatic feed’ is enabled, you should bear in mind that the original is
automatically pulled into the scanner. If you want to be absolutely sure about
the settings that belong to an original, insert an original when the settings are
correct.
Note: You can turn off Automatic feed on the scanner. This offers you the
possibility to change the settings for the next original, even if you already put
the original in place on the scanner feed table.
▼ Define settings for the next copy job
1 Select all settings required for the next original.
2 Insert the next original.
If ‘Automatic feed’ is off, press the start key.
If ‘Automatic feed’ is on, the original is fed automatically.
Note: You can enable or disable this function from the ‘Scanner’ card in the
‘Original’ section.
Account logging
For accounting purposes, the system is able to log job information for each job.
The job identification attributes and the number of print jobs are logged in the
account file. For more information on account logging see chapter 10 on
page 171.
Note: The account settings are only available if the accounting option is
enabled in the system configuration.
[20] Accounting function