IBM Oce TDS800 - Manual (Page 72)

72 Océ TDS800 User Manual
Make a scan-to-file
Do the following to scan an original to file.
▼ How to scan to file
1 Place your original face-up, left aligned along the original guide.
2 Select the appropriate original type.
3 Select the ‘Destination’ card in the ‘File’ section.
[24] ‘Destination’ card in the file section
4 Select ‘File mode’ On.
The status message displays: Ready to scan to file.
5 Select a Destination (see ‘Destinations’ on page 82).
6 Set the correct settings. (see Chapter , ‘Settings for scan-to-file’ on page 74)
7 Press the start key .
The original is scanned.
A status message displays (see Figure 25 on page 72):
‘Scanning job’ ‘Scan job number X’
‘File scan22.tif’
[25] File card on the Scanner operator panel