GE 45246 GE Wireless Color Camera with AV Receiver - Manual (Page 15)

15
- 3/16" drill bit (for drilling holes, if using plastic
anchors to mount onto drywall or brick material)
- Screwdriver
- Adjustment wrench (included)
Step 1. Mounting preparation
Once a suitable location for the
camera has been selected and
the cable route has been
determined, you will need to use
the camera’s mounting bracket
as a template to mark holes for
drilling. Mark three holes on the
wall for the anchors or screws as shown. Please take
care to mark the center of the holes.
Note: Before mounting camera permanently,
check to ensure the appropriate channel has been
selected (see Channel Selection) to provide good
reception at the receiver/monitor.
Step 2. Cable routing -IMPORTANT
(a) If running the cable along the wall surface,
position cable through slot at base of mounting
bracket before installing mounting bracket (see
figure A).