GE 45246 GE Wireless Color Camera with AV Receiver - Manual (Page 6)

6
• Avoid positioning the camera so that it is viewing
areas where half of the area is in bright sunlight
and the other half is dark, such as the shadow
of a building. All types of cameras have difficulty
“seeing” into areas of such divergent light levels.
• In low light conditions, the camera will
automatically activate its high-powered Infrared
(IR) LED’s and switch the camera to Long Range
Night Vision mode. Long Range Night Vision
viewing distance can be up to 60ft, and will be
viewed in B/W.
• The included AC adapters must be positioned
no farther than 8’ from an AC outlet. Do not use
either supplied adapter outside. If you need to
extend an AC adapter cable, 12 ft. extensions
are available by contacting Technical Support at
800-654-8483.
• The Camera has an unobstructed wireless
transmission range up to 200 ft. from the
receiver. Transmission distance indoors is
reduced due to interior walls, wiring, household
fixtures and metal plumbing.
RECEIVER CHANNEL SELECTION
The receiver system can monitor up to 2 wireless
cameras. You can operate the receiver in either
Manual or Auto mode. To view more than one
camera, locate the camera channel selection
switch (1 2 1/2) on the rear panel of the
receiver.
The receiver must be set to the ‘1/2’ position to
allow two cameras to be monitored. The next step
will be to set the channel selection switch on both
cameras. See Camera Channel Selection.
MANUAL MODE
Operating the receiver in
manual mode allows you
to manually select a single
camera/channel to monitor
exclusively. The system will
remain on the selected
channel indefinitely until the
other channel is selected. To select one of the two
channels (cameras) manually, locate the AUTO
and MANUAL buttons on the top of the receiver.
Press and release the MANUAL button. The red LED
labeled ‘A — M’ will turn on and the corresponding
Auto
Manual
Channel
Selection
switch