GE 45246 GE Wireless Color Camera with AV Receiver User Manual
Page 9
9
CYCLE TIME SETTING (Time interval between
camera selections)
The default cycle time for the receiver to switch
between cameras in auto mode is preset to 4
seconds. To change the cycle time, press and hold
both of the buttons (Auto and Manual) on top of
the receiver simultaneously. The receiver will beep,
pause and then sound a beep for each second of
the cycle time, up to 30 seconds. The total cycle
time can be verified by the number of LED flashes/
beeps made when you release the buttons—one
flash/beep equals one second. Cycle time can be
set between 4-30 seconds.
If the power adapter is
removed or the receiver loses power, the cycle
time defaults back to 4 seconds.
CAMERA CHANNEL SELECTION
This wireless surveillance system is designed to
monitor up to two cameras. Additional cameras are
sold separately.
IMPORTANT: When using more than one camera,
each camera must be assigned to a specific
channel using the channel selection switch
located on the inside the front of the camera
housing.