JVC KD-AHD39 - Manual (Page 20)

20
ENGLISH
Connecting a special device
In step ! on page 19...
1
Select “SPECIAL.”
The unit displays device names.
2
Select the device you want to connect.
3
Use “OPEN” (see page 19) or “SEARCH” (see
left) to connect.
Connecting/disconnecting a
registered device
1
2
Select the registered device you want
to connect/disconnect then enter the
Bluetooth menu.
3
Select “CONNECT” or “DISCONNECT” to
connect/disconnect the selected device.
You can set the unit to connect a Bluetooth device
automatically when the unit is turned on (see page 24).
4 Operate the target Bluetooth device while “OPEN..”
is flashing on the screen.
Enter the same PIN code (as entered in step 2) into
the device to be connected.
Now the connection is established and you can use the
device through the unit.
The device remains registered even after you
disconnect it. Use “CONNECT” (or activate
“AUTO CNNCT”) to connect the same device from next
time on (see right and page 24).
Registering using “SEARCH”
In step ! on page 19...
1 Select “SEARCH.”
The unit searches for available devices and displays
them. (If no available device is detected, “UNFOUND”
appears.)
2 Select the device you want to connect.
3 Enter the specific PIN code of the device into the
unit.
• Refer to the instructions supplied with the device to
check the PIN code.
4 Use the Bluetooth device to connect.
Now the connection is established and you can use the
device through the unit.
EN_KDHDR30AHD39_f.indb 20 EN_KDHDR30AHD39_f.indb 20 07.11.16 6:50:11 PM 07.11.16 6:50:11 PM