JVC TK-C1460 - Manual (Page 12)

E-12
REC
PLAY
FF REW
REVERSE PAUSE/ STILL
REC CHECK STOP/EJECT
COUNT/
CLOCK
TIME
MODE TIMER REC AL/PL
RESET
MENU
VIDEO CASSETTE RECORDER
SHIFT/TRACKING
SET/V.LOCK
RESET /CANCEL
OPERATE
SR-L910
OPE. LOCK
1
TO CAMERA TO CAMERA DATA I / O DATA I / O RX+ RX- TX+ TX- COM COM 1 2 3 4 5 6 7 8 COM COM 9/1 9/1 10/2 10/2 11/3 11/3 12/4 12/4 13/5 13/5 14/6 14/6 15/7 15/7 16/8 16/8 COM COM COM COM COM COM CAMERA CAMERA SW SW UNIT UNIT ALARM ALARM AUTO AUTO
4 3 1 2 8 7 5 6
2 3 4 5 6 7 8
1
MONITOR MONITOR OUTPUT MONITOR MONITOR
SERIAL-2 SERIAL-1 SERIAL-1
VIDEO INPUT
VIDEO OUTPUT VIDEO OUTPUT
OUTPUT OUTPUT 2
1 ON 2 3 4 5 6 7 8
POWER
OFF
AC INPUT
ALC
LEVEL
Av Pk
L H
ALC
LEVEL
Av Pk
L H
ALC
LEVEL
Av Pk
L H
• • • • •
CAMERA
SW
Remote Control Unit
RM-P2580
Time lapse VCR
MONITOR
MONITOR
CAM SW
OUT
VIDEO IN
COM
TO
CAMERA
MONITOR
OUTPUT 2
MONITOR
OUTPUT 1
CONNECTION/INSTALLATION
RM-P2580 System
Ⅲ System with up to 8 cameras
Camera
TK-C1460
Camera
TK-C1460
Camera
TK-C1460
Camera 1
Camera 2
Camera 8
Control signal cable
Video signal cable
Power
cable
AC24V
or
DC12V
AC24V
or
DC12V
AC24V
or
DC12V
When controlling with any system except the RM-P2580, execute proper settings using
switches and menu screens according to the systems used. (
੬ Page 14)
MACHINE ID:1
(Menu screen)
RX TERM: OFF
(switch)
MACHINE ID:2
(Menu screen)
RX TERM: OFF
(switch)
MACHINE ID:8
(Menu screen)
RX TERM: ON
(switch)
MEMO
• When operating a system using the RM-P2580, several cameras (up to 16) can be
connected and used on one control signal cable. Consequently, an incorrect switch setting
on just a single camera will cause the entire system to work incorrectly.
• Confirm switch settings on the screen as follows.
q Confirm that the image from the camera to be checked
is displayed on the monitor.
w Turn OFF and then ON the AC 24 V power to the
camera to be checked.
e The camera begins the initial operation and charac-
ters similar to those shown in the illustration on the
right appear on the monitor screen.
r Confirm that “DUPLEX” and “ID- □□” are displayed
and that the ID number is the correct number (the
number should be the same as the number of the
VIDEO INPUT terminal to which the camera is con-
nected on the rear panel of the RM-P2580).
t If wrong, set the camera ID again.
MONITOR screen
(example showing camera ID as “05”)
P R O T O O L D U P L E X I D - 0 5 C :
“DUPLEX” should
be displayed. The number shown in the
□□ part of ID-□□
should be correct.