Juniper Networks Juniper M-series M10i - Manual (Page 47)

Gigabit Ethernet PIC with SFP
■ JUNOS 6.3 and later Software release
■ One Gigabit Ethernet port
■ Power requirement: 0.15 A @ 48 V (7.3 W)
■ Supports large Ethernet frame sizes for more efficient throughput across the intra-POP
network
Description
■ High-performance throughput on each port at speeds up to 1 Gbps
■ Autonegotiation between Gigabit Ethernet circuit partners
■ Full-duplex mode
■ Maximum transmission units (MTUs) of up to 9192 bytes
Hardware features
■ Virtual Router Redundancy Protocol (VRRP) support
■ 802.1q virtual LANs (VLANs) support
■ 960 destination MAC filters per port
■ Flexible Ethernet encapsulation
■ Multiple tag protocol identifiers (TPID) support
■ Source MAC learning
■ MAC accounting and policing—Dynamic local address learning of source MAC addresses
Software features
■ You can install any transceiver supported by the PIC. For information about installing
and removing transceivers, see the PIC and Transceiver Installation Instructions.
■ Fiber-optic SFP transceivers:
■ Duplex LC/PC connector (Rx and Tx)
■ Optical interface support—See Table 9 on page 48
■ 1000Base-T SFP transceivers:
■ Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
■ Pinout: MDI crossover
■ Length: 328 ft/100 m
NOTE: Do not install Gigabit Ethernet SFPs in the SONET/SDH port. The port will not recognize
the SFP.
Cables and connectors
Gigabit Ethernet PIC with SFP ■ 47
Gigabit Ethernet PIC with SFP