Juniper Networks Juniper M-series M10i - Manual (Page 49)

Gigabit Ethernet IQ PIC with SFP
■ JUNOS 6.1 and later Software release
■ One Gigabit Ethernet port
■ Power requirement: 0.46 A @ 48 V (22 W)
■ Intelligent queuing (IQ) PICs support fine-grained queuing per-logical interface.
Description
■ High-performance throughput at speeds up to 1 Gbps
■ Full-duplex mode
■ Large MTUs of up to 9192 bytes
Hardware features
■ Optical diagnostics and related alarms (JUNOS Release 8.2 and later)
■ Quality of service (QoS) per channel: Weighted round-robin (WRR), Random early drop
(RED), Weighted random early drop (WRED)
■ Virtual Router Redundancy Protocol (VRRP) support
■ 802.1Q Virtual LANs
■ VLAN stacking and rewriting
■ MAC policing, accounting, and filters
■ Flexible Ethernet encapsulation
■ JUNOS Release 7.0 or later is required to configure graceful Routing Engine switchover
(GRES).
Software features
■ The Gigabit Ethernet IQ PICs use small form factor-pluggables (SFPs) that allow different
interfaces to be used on the PIC. For information about installing and removing SFPs,
see the M10i Internet Router Hardware Guide.
■ SX, LX, and LH SFPs:
■ Duplex LC/PC connector (RX and TX)
■ Optical interface support—See Table 10 on page 50
■ 1000Base-T SFPs:
■ Connector: Four-pair, Category 5 shielded twisted pair connectivity through an RJ-45
connector
■ Pinout: MDI crossover
■ Length: 328 ft/100 m
Cables and connectors
Gigabit Ethernet IQ PIC with SFP ■ 49
Gigabit Ethernet IQ PIC with SFP