Juniper Networks Juniper M-series M10i - Manual (Page 54)

Link Services PIC
■ JUNOS 6.1 and later Software release
■ Power requirement: 0.17 A @ 48 V (8 W)
■ Three versions:
■ 4 multilink bundles, 256 LFI links
■ 32 multilink bundles, 256 LFI links
■ 128 multilink bundles, 256 LFI links
■ Multilink bonding, link fragmentation and interleaving (LFI), and tunneling
Description
■ Rate limiting/policing per multilink bundle
■ Byte-wise load balancing across multilink bundles
■ Bonding T1 links enable service ranging from 1.5 Mbps through 12 Mbps
■ Bonding E1 links enable service ranging from 2 Mbps through 16 Mbps
■ Loopback function that encapsulates and de-encapsulates packets
Hardware features
For a list of the software features available for services PICs, see the JUNOS Services Interfaces
Configuration Guide.
■ Protocol support:
■ Multilink PPP (MLPPP)
■ Multilink Frame Relay (MLFR)—FRF.15 and FRF.16
■ Link fragmentation and interleaving (LFI)—FRF.12
■ LFI over MLPPP
■ IP-IP unicast tunneling
■ GRE unicast tunneling
■ PIM sparse mode unicast tunneling
Software features
One bicolor:
■ Off—PIC is offline
■ Green—PIC is online and at least one configured bundle is operating
■ Amber—PIC is online, but no configured bundles are operating
LEDs
54 ■ Link Services PIC
M10i Internet Router PIC Guide