JVC RM-LP25U - Manual (Page 18)

8
Connection
Standard connection of the RM-HP790DU/
RM-HP790DE (Connection of a single unit)
Ⅵ When the RM-HP790DU/RM-HP790DE is connected to a camera.
Memo :
● When the RM-HP790DU/RM-HP790DE is connected to a camera, a local remote controller cannot be connected to the camera.
* 1 When connect the remote control unit cable to the [REMOTE] connector, please be careful to the following points.
● To reduce the emission of unwanted radio waves and to avoid electrostatic influence, be sure to attach the provided clamp
filter attached in RM-LP25U as shown in the figure.
● Attach the clamp filter as close to connector as possible.
* Models with an E suffix are for the European market and the UL Listing mark is not applicable.
Example of Basic
Connection
REMOTE
Y/G P B /B P R /R
ACHIN AC120V 60Hz
TALLY
PGM PVW C
INTERCOM AUX VIDEO INPUT GENLOCK INPUT
VIDEO OUTPUT
H
RTS
C G
COMPOSITE VIDEO CAMERA CABLE
HD/SD SDI
INPUT OUTPUT
*1
GY-HM790U/GY-HM790CHU/
GY-HM790E*/GY-HM790CHE*
Studio Viewfinder
VF-HP790G
Studio Adapter KA-790G
Headset
(Beyerdynamic)
Multicore Remote Adapter
KA-M790G
Camera Cable (26Pin)
VC-P110U (5m)
VC-P112U (20m)
VC-P113U (50m)
VC-P114U (100m)
Camera Remote Control Unit
RM-HP790DU/RM-HP790DE
Remote Control Unit
RM-LP25U
Monitor
Clamp filter
Wind once
To power supply
Headset
(Beyerdynamic)
Coaxial cable
(The illustration shows the RM-HP790DU.)