Fluid level checks, Checking the engine oil level – Jaguar XJ User Manual

Page 161

Advertising
background image

R

(FM8)

SEMCON JLR OWNER GUIDE VER 1.00

EURO

LANGUAGE: english-en;

MARQUE: jaguar;

MODEL: XJ

Fluid level checks

161

Fluid level checks

CHECKING THE ENGINE OIL LEVEL

Check the engine oil weekly. If any
significant or sudden drop in oil level is
noted, seek qualified assistance.

If the message ENGINE OIL PRESSURE
LOW
is displayed, stop the engine as
soon as it is safe to do so and seek
qualified assistance. Do not start the
engine until the cause has been
rectified.

Prior to checking the oil level ensure that the
vehicle is on level ground.

All except V6 petrol engines
• The engine oil has reached working

temperature (oil is hot).

• The engine has been switched off for ten

minutes, as the system will not give an
accurate reading until the oil level has
stabilised.

The oil level can then be checked as follows:

1. Switch on the ignition (do not start the

engine).

2. Ensure Park (P) is selected.

3. Select the Service menu using the

instrument panel menu joypad control (see
53, INTERACTIVE CONTROLS).

Select Oil level display from the Service
menu. The current oil level status and
topping-up advice is displayed in the
instrument panel, top-up as instructed.

An indication of the oil level is displayed in the
gauge. Messages to the right of the gauge
advise you of any action you may need to take.

If the oil level is within the required operating
range, the message Engine Oil Level OK will
be displayed. Do not add any additional oil to
the engine.

If the oil level is below the required operating
range, a message advising you how much oil to
add will be displayed (e.g. Add 0.5 Litre). Add
the recommended quantity of oil.

If the message Engine Oil Level Overfilled is
displayed, seek qualified assistance
immediately. Do not drive the vehicle as this
will cause serious damage to the engine.

If the message Engine Oil Level Underfilled is
displayed, add 1.5 litres (2.6 pints) of oil, then
recheck the level.

If the message Engine Oil Level Not Available
is displayed, the oil level is stabilising. Switch
off the ignition, wait 10 minutes, then recheck
the oil level display.

If the warning message ENGINE OIL LEVEL
MONITOR SYSTEM FAULT
is displayed, seek
qualified assistance.

V6 petrol engines

Note: If it is necessary to check the oil level
when the engine is hot, switch off the engine
and let stand for five minutes to allow the oil to
drain into the sump. Do not start the engine.

Advertising