Jotul GF3 DVII - Manual (Page 5)

Standards
This appliance complies with National Safety stan-
dards and is tested and listed by Intertek Testing
Services of Middleton, WI
In addition, the Jøtul GF3 DVII Allagash gas stove
complies with and has been tested and listed as a
direct vent heater and listed to ANSI Z21.88-1998
(NFPA 54), and CSA 2.33-M98 for Canada.
DO NOT ATTEMPT TO ALTER OR MODIFY
THE CONSTRUCTION OF THE APPLIANCE
OR ITS COMPONENTS. ANY MODIFICA-
TION OR ALTERATION WILL VOID THE
WARRANTY, CERTIFICATION AND LISTING
OF THIS APPLIANCE.
General Information
• THIS HEATER MUST BE INSTALLED AND MAIN-
TAINED BY A QUALIFIED SERVICE AGENCY.
• The installation and repair of this appliance must
be done by a qualified service person. Failure to
properly install and maintain this heater could
result in an unsafe or hazardous installation,
which may result in a fire, explosion, property
damage, personal injury or loss of life.
• This appliance should be inspected before use and
at least annually. More frequent cleaning may be
required due to excessive lint from carpeting,
bedding material, etc. It is imperative that control
compartments, burners and circulating air pas-
sageways of the appliance be kept clean.
• NOTE: THIS APPLIANCE MUST NOT BE CONNECTED
TO A CHIMNEY OR FLUE SERVING ANY OTHER
APPLIANCE.
• The installation must conform to local codes. Your
local Jøtul dealer can assist you in determining
what is required in your area for a safe and legal
installation. Some areas require a permit to
install a gas burning appliance. Always consult
your local building inspector or authority having
jurisdiction to determine what regulations apply
in your area.
• Your local officials have final authority in deter-
mining if a proposed installation is acceptable.
Any requirement that is requested by the local
authority having jurisdiction, that is not specifi-
cally addressed in THIS manual, defaults to local
code. In the absence of local codes, the installa-
tion requirements must comply with the current
National codes. In the U.S. these requirements are
• DO NOT OPERATE THIS STOVE IF ANY PART HAS
BEEN UNDER WATER. Immediately call a qualified
service technician to inspect the heater and to
replace any part of the control system and any
gas control which has been under water.
• Ne pas se servir de cet appareil s’il a ete’ plonge
dans l’eau, completement ou en partie. Appeler
un technicien qualifie pour inspecter l’appareil et
remplacer toute partie du syste’me de controle et
toute commande qui ont ete plonges dans l’eau.
Glass Front
Do not operate this appliance with the glass front
removed, cracked or broken. Replacement of the
glass should be done by a licensed or qualified
service person. Only remove glass for routine
service. Always handle glass carefully.
3
established in the National Fuel Code, ANSI
Z223.1.(NFPA 54). In Canada, the codes have been
established in CAN/CGA B149 Fuel Installation
Code.
• Installer l’appareil selon les codes ou reglements
locaux, ou, en l’absence de tels reglements, selon
les Codes d’installation CAN/CGA-B149.