JVC HR-DD840KR - Manual (Page 40)

40
EN
G-C
ODE
Timer
Programming
Timer recording allows you to program the VCR to automati-
cally record a program which will be broadcast at some future
time.
The timer record function can be programmed using G-CODE
or On-Screen Timer Programming. (
੬
pg. 40 or 42)
During G-C ODE and on-screen programming, the Illumi-Guide
feature tells you which button on the remote control must be
pressed next by lighting the relevant buttons. The Illumi-Guide
feature is activated by the ILLUMI GUIDE button on the remote
control. The Illumi-Guide feature is only active when the
remote control's TV/CABLE/VCR switch is set to "VCR". (Illumi-
Guide is an optional help feature which makes programming
easier. It is not necessary to use Illumi-Guide to program the
VCR.)
TIMER RECORDING
G-CODE
PRESS NUMBER KEY (0-9)
PRESS (MENU) TO MAIN MENU
LOAD A CASSETTE
1
Make sure the record safety tab is present.
● The VCR’s power comes on automatically.
ACCESS G-CODE SCREEN
2
To use the Illumi-Guide
feature press ILLUMI
GUIDE. The MENU, REW,
PLAY and FF buttons will
light.
Press MENU on the remote
control.
● The clock must be set in
order to access the G-
C
ODE screen. If you haven’t set the clock, the Main
Menu screen appears when you press MENU. Refer
to page 5 for the Plug & Play procedure or page 7 for
the clock setting procedure.
● If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys (0 –
9), PUSH JOG, CANCEL and MENU.
ENTER G-CODE NUMBER
3
Press the appropriate NUMBER keys to enter the G-
C
ODE number printed in the TV listings for the TV
program you wish to record.
● To make corrections, press CANCEL and input the
correct G-C ODE number.
● If the G-C
ODE number you input is incorrect,
"ERROR" may appear on the screen to advise you of
the error. This happens when the G-C
ODE number is
for a program which has already passed. "ERROR" is
displayed for about 4 seconds and the G-C
ODE screen
reappears (step 2).
● If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys
(0 – 9), PUSH JOG, CANCEL and MENU.
When Using The Illumi-Guide Feature
● Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press MENU as many times as necessary to return to the
normal screen and extinguish all illuminated buttons,
and re-perform the timer programming procedure from the
beginning.
● If for some reason the remote control's signal is not received
by the VCR, press MENU as many times as necessary to
return to the normal screen and extinguish all
illuminated buttons, and re-perform the timer programming
procedure from the beginning.
● Before G-C
ODE Timer programming, see "G-C ODE Setup"
on page 16.
● Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
1 2
4 5
3
6
8
0
7 9
ILLUMI GUIDE
q
TV/CABLE/VCR
MENU
OK
CANCEL
NUMBER