JVC HR-DD840KR - Manual (Page 53)

EN
53
SPECIAL FEATURES
TV Multi-Brand Remote
Control
The VCR's remote control can control several functions on JVC
remote control TVs and on the brands of remote control TVs
listed below.
1 2
4 5
3
6
8
0
7 9
POWER
TURN ON THE TV
1
Turn the power on using the TV's remote control.
SET REMOTE CONTROL
MODE
2
Set the TV/CABLE/VCR switch on the VCR's remote
control to TV.
SET TV BRAND CODE
3
Refer to the chart below. While holding down POWER
on the VCR's remote control, enter your TV’s brand
code using the NUMBER keys, then press STOP.
Follow the example shown at bottom left.
● Once you have set the remote control to operate the
TV, you don’t have to repeat this step until you
replace your remote control’s batteries.
● GRADIENTE has four codes. If the TV does not
function with one code, try entering another.
OPERATE TV
4
First, press POWER on the remote to see if the TV’s power
goes off as it should. If it does, try other operations.
● The POWER, TV/VCR, CH5∞, TV VOL. +/– and
NUMBER keys on the remote can all be used to
operate the TV. *For some brands of TV, you must
press ENTER after having pressed the NUMBER keys.
● If you have a JVC TV equipped with Hyper Surround
or Live Effex, the button may work to operate it.
● To return the remote to VCR control, set the TV/
CABLE/VCR switch to VCR.
NOTE:
Depending on the kind of TV, there may be cases where some
or all functions cannot be operated using the remote control.
STOP
POWER
3 0 Release
Hold
down Press in succession
(Ex.) To set remote control to PHILIPS 03:
TV BRAND NAME BRAND CODE
JVC 01
GRADIENTE 02, 11, 12, 16
PHILIPS 03
CCE 03
SANYO 04
PHILICO/HITACHI 05
SHARP 06
TOSHIBA 07
MITSUBISHI 08
PHILICO/DAEWOO 09
SAMSUNG 10
GOLDSTAR 11
RCA 12
PANASONIC 13
GRUNDIG 14
SONY 15
NEC 16
PHILICO 17
NOBLEX 18
NUMBER
ENTER
CH
TV/CABLE/VCR
TV VOL. +/–
STOP
TV/VCR