JVC HR-DD840KR - Manual (Page 55)

EN
55
DBS Receiver Multi-Brand
Remote Control
The VCR's remote control can control functions on the brands
of DBS (Direct Broadcast Satellite) receivers listed below.
1 2
4 5
3
6
8
0
7 9
POWER
ENTER
TURN ON THE DBS
RECEIVER
1
Turn the power on using the DBS receiver’s remote
control.
SET REMOTE CONTROL
MODE
2
Set the TV/CABLE/VCR switch on the VCR’s remote
control to CABLE.
ENTER DBS RECEIVER
BRAND
3
While holding down POWER on the VCR's remote
control, use the NUMBER keys to enter the DBS receiver
brand number from the chart below and then press STOP.
Follow the example shown at bottom left.
● Once you have set the remote control to operate the
DBS receiver, you don't have to repeat this step until
you replace the remote control's batteries.
OPERATE DBS RECEIVER
4
First, press POWER to see if the DBS receiver’s power
goes off as it should. If it does, try other functions (CH
5∞ and the NUMBER keys can be used to operate the
DBS receiver).
● For some brands of DBS receiver, you must press
ENTER after having pressed the NUMBER keys.
● To return the remote to VCR control, set the TV/
CABLE/VCR switch to VCR.
NOTES:
● Depending on the kind of DBS receiver, there may be cases
where some or all functions cannot be operated using the
remote control.
● You must set the DBS receiver brand for your remote control
and the DBS receiver brand for your Controller (
੬
pg. 20)
separately.
● It is possible that the remote control will not operate your DBS
receiver even if the DBS receiver’s channels automatically
change during timer recording using the Controller.
● It's not possible to set the remote control for both your cable
box and your DBS receiver at the same time; you can only set
the remote control to the brand of either one.
● You have to subscribe to a DBS broadcaster to receive DBS
channels.
STOP
TV/CABLE/VCR
CH
NUMBER
(Ex.) To set remote control to RCA 80:
STOP
POWER
8 0 Release
Hold
down Press in succession
DBS BRAND NAME BRAND CODE
RCA (DSS) 80
SONY (DSS) 81
PRIMESTAR 90