Service – John Deere GP-2700GH User Manual

Page 27

Advertising
background image

Operator’s Manual

7

ENGINE: The engine instructions that accompany your unit detail specific

procedures for maintenance of the engine. Following the engine

manufacturer’s recommendations will extend engine work life.

PUMP:

The pump oil must be changed after the first 25 hours of operation.

Once the initial oil change has been completed, it is recommended

the oil be changed every  months or 50 hour intervals. If oil

appears dirty or milky, changes may be required at a greater

frequency. Use John Deere Hy-Guard pump oil and fill only to the

center of the oil sight glass. DO NOT OVERFILL!

NOZZLES: Water flow through the spray nozzle will erode the orifice, making

it larger, resulting in a pressure loss. Nozzles should be replaced

whenever pressure is less than 85% of the maximum. The frequency

of replacement will depend upon such variables as mineral content

in the water and number of hours the nozzle is used.

QUICK COUPLERS: There is an o-ring seal inside the female quick coupler.

This o-ring will deteriorate or, if the unit is allowed to pump without

the high pressure hose or nozzle attached, the o-ring may be blown

out occasionally. Simply insert a replacement o-ring to correct the

leak. (Additional o-rings can be purchased from your dealer.)

BELT TENSION ADJUSTMENT: To maintain peak performance of your pressure

washer, it may be necessary to adjust the belt tension on occasion.

Follow the procedure outlined below.

. Remove the belt guard and loosen the four bolts on the pump

(Reference A).

. Turn the cap screw (Reference B) clockwise until a / inch

belt deflection is noticed between the pulleys.

. Tighten the bolts. (Reference A)

4. Put a straight edge across both pulleys. If necessary, loosen

one set of pulley screws and adjust in or out to properly align.

Tighten the pulley screws and check the tension again.

5. Replace the beltguard and tighten the fasteners securely.

NOTE: If the belt needs to be replaced, the replacement belt must be

Oil-Heat Resistant and Static Dissipating.

Service

Advertising