An ex series switch – Juniper Networks EX2200 User Manual

Page 102

Advertising
background image

Figure 35: Connecting a Fiber-Optic Cable to an Optical Transceiver
Installed in an EX Series Switch

g027016

Fiber-optic cable

Transceiver

4.

Secure the cables so that they are not supporting their own weight. Place excess cable
out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain
their shape.

CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius. An arc smaller than a few inches in diameter can damage the cables
and cause problems that are difficult to diagnose.

Do not let fiber-optic cables hang free from the connector. Do not allow
fastened loops of cables to dangle, which stresses the cables at the
fastening point.

Related

Documentation

•

Disconnecting a Fiber-Optic Cable from an EX Series Switch on page 97

•

Installing a Transceiver in an EX Series Switch on page 65

•

Maintaining Fiber-Optic Cables in EX Series Switches on page 101

•

Optical Interface Support in EX2200 Switches on page 22

•

Optical Interface Support in EX3200 Switches

•

Optical Interface Support in EX4200 Switches

•

Optical Interface Support in EX4500 Switches

•

Optical Interface Support in EX8200 Switches

Copyright © 2010, Juniper Networks, Inc.

82

Complete Hardware Guide for EX2200 Ethernet Switches

Advertising