Juniper Networks EX2200 - Manual (Page 95)

Figure 29: Ethernet Cable Connector
To connect a device to a network for out-of-band management (see Figure 30 on
page 75):
1. Connect one end of the Ethernet cable to the management port (labeled MGMT ) on
the device.
For the location of the MGMT port on different devices:
• See “Rear Panel of an EX2200 Switch” on page 6.
• See Rear Panel of an EX3200 Switch.
• See Rear Panel of an EX4200 Switch.
• See Front Panel of an EX4500 Switch.
• See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch.
• See Routing Engine (RE) Module in an EX8216 Switch.
• See Front Panel of an XRE200 External Routing Engine.
2. Connect the other end of the Ethernet cable to the management device.
Figure 30: Connecting an EX Series Switch to a Network for Out-of-Band
Management
g020548
Management PC
Management PC
Management PC
To Management port
(on the switch)
Management
network
Related
Documentation
Connecting an EX Series Switch to a Management Console on page 76 •
• Management Port Connector Pinout Information for an EX2200 Switch on page 22
• Management Port Connector Pinout Information for an EX3200 Switch
• Management Port Connector Pinout Information for an EX4200 Switch
75 Copyright © 2010, Juniper Networks, Inc.
Chapter 10: Connecting the Switch