Juniper Networks EX2200 - Manual (Page 41)

Related
Documentation
Front Panel of an EX2200 Switch on page 5 •
Console Port Connector Pinout Information for an EX Series Switch
The console port on an EX Series switch is an RS-232 serial interface that uses an RJ-45
connector to connect to a console management device. The default baud rate for the
console port is 9600 baud.
Table 11 on page 21 provides the pinout information for the RJ-45 console connector. An
RJ-45 cable and an RJ-45 to DB-9 serial port adapter are supplied with the switch.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to an EX Series switch, use a
combination of the RJ-45 to DB-9 female adapter supplied with the switch
and a USB to DB-9 male adapter. You must provide the USB to DB-9 male
adapter.
Table 11: EX Series Switches Console Port Connector Pinout Information
Description Signal Pin
Request to send RTS Output 1
Data terminal ready DTR Output 2
Transmit data TxD Output 3
Signal ground Signal Ground 4
Signal ground Signal Ground 5
Receive data RxD Input 6
Data carrier detect CD Input 7
Clear to send CTS Input 8
Related
Documentation
See Rear Panel of an EX2200 Switch on page 6 for port location. •
• See Rear Panel of an EX3200 Switch for port location.
• See Rear Panel of an EX4200 Switch for port location.
• See Front Panel of an EX4500 Switch for port location.
• See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch for port
location.
• See Routing Engine (RE) Module in an EX8216 Switch for port location.
21 Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Component Specifications