Table 16: site electrical wiring guidelines – Juniper Networks EX2200 User Manual

Page 56

Advertising
background image

Table 16: Site Electrical Wiring Guidelines

Guidelines

Site Wiring Factor

If your site experiences any of the following problems, consult
experts in electrical surge suppression and shielding:

Improperly installed wires cause radio frequency interference
(RFI).

Damage from lightning strikes occurs when wires exceed
recommended distances or pass between buildings.

Electromagnetic pulses (EMPs) caused by lightning
damages unshielded conductors and electronic devices.

Signaling limitations

To reduce or eliminate radio frequency interference (RFI) from
your site wiring, do the following:

Use twisted-pair cable with a good distribution of grounding
conductors.

If you must exceed the recommended distances, use a
high-quality twisted-pair cable with one ground conductor
for each data signal when applicable.

Radio frequency interference

If your site is susceptible to problems with electromagnetic
compatibility (EMC), particularly from lightning or radio
transmitters, seek expert advice.

Some of the problems caused by strong sources of
electromagnetic interference (EMI) are:

Destruction of the signal drivers and receivers in the switch

Electrical hazards as a result of power surges conducted
over the lines into the equipment

Electromagnetic compatibility

Related

Documentation

General Safety Guidelines and Warnings for EX Series Switches on page 113

General Electrical Safety Guidelines and Warnings for EX Series Switches on page 141

Prevention of Electrostatic Discharge Damage on EX Series Switches on page 142

Power Supply in EX2200 Switches on page 14

Power Supply in EX3200 Switches

Power Supply in EX4200 Switches

AC Power Supply in EX4500 Switches

DC Power Supply in EX4500 Switches

AC Power Supply in an EX8200 Switch

DC Power Supply in an EX8200 Switch

Environmental Requirements and Specifications for EX Series Switches

The switch must be installed in a rack or cabinet housed in a dry, clean, well-ventilated,
and temperature-controlled environment.

Copyright © 2010, Juniper Networks, Inc.

36

Complete Hardware Guide for EX2200 Ethernet Switches

Advertising