Juniper Networks EX2200 - Manual (Page 76)

• Phillips (+) screwdriver, number 2
• 2 mounting brackets and 8 mounting screws (provided in the accessory compartment
in the switch carton)
• Screws to secure the chassis to the rack (not provided)
• 2-in.-recess front brackets if you will mount the switch in a recessed position (brackets
from the separately orderable four-post rack-mount kit)
NOTE: One person must be available to lift the switch while another secures
the switch to the rack.
CAUTION: If you are mounting multiple units on a rack, mount the heaviest
unit at the bottom of the rack and mount the other units from the bottom of
the rack to the top in decreasing order of the weight of the units.
To mount the switch on two posts in a rack:
1. Place the switch on a flat, stable surface.
2. Align the mounting brackets along the front or rear of the side panels of the switch
chassis depending on how you want to mount the switch. For example, if you want
to front-mount the switch, align the brackets along the front of the chassis. See Figure
15 on page 56.
Figure 15: Attaching the Mounting Bracket Along the Front of the Switch
g027019
SYS ALM SPD
DX
EN
POE
NOTE: If you need to mount the switch in a recessed position, use the
2-in.-recess front mount brackets from the separately orderable four-post
rack-mount kit.
3. Align the bottom holes in the mounting brackets with holes on the side panels of the
switch chassis.
4. Insert the mounting screws into the aligned holes. Tighten the screws.
5. Ensure that the other holes in the mounting brackets are aligned with the holes in the
side panels. Insert a screw in each hole and tighten the screws.
Copyright © 2010, Juniper Networks, Inc. 56
Complete Hardware Guide for EX2200 Ethernet Switches