John Lewis JLRC101 - Manual (Page 26)

26
Something Not Working
If the appliance is not working correctly, please carry out
the following checks before contacting your local Service
Force agent.
IMPORTANT : If you call out an engineer to a
fault listed below, or to repair a fault caused
by incorrect use or installation, a charge will
be made even if the appliance is under
guarantee.
Symptom Solution
The ignition does not work: • The plug is not properly inserted in the power socket.
• There is no current at the socket.
The burner does not ignite: • The gas is turned off.
• There is no ignition spark.
The flame has no uniform distribution: • The burner plate is improperly assembled.
• The burner is dirty.
The inner lamp is not working: • The plug is not properly inserted in the power socket.
• There is no current at the socket.
• The lamp is defective.
The oven is not warming up: • The plug is not properly inserted in the power socket.
• There is no current at the socket.
The display light is blinking: • There has been a current interruption, the display needs to be
programmed again (see page 14).