JVC SR-VDA300U - Manual (Page 26)

26
EN
S-VIDEO VIDEO
MENU
(MONO) L R AUDIO
REC LINC
POWER
IN F-1
TIMER STOP/EJECT
HS /STD/LS3
SP/EP
PLAY
REC PAUSE
PRO HD REW FF
3DNR
CH
S-ET
DIGITAL 3-D NR
S-VHS ET
ASI-IN ASI-REC
POWER
PULL-OPEN
Basic
Recording
This VCR can check the tape condition during recording
(and playback), and realizes the best possible pictures.
Turn on the VCR and the TV, and select the AV
mode on the TV.
1
1 2 3
4 5 6
7 8 9
0
VCR TV CABLE/DBS
STOP ( 7 )
FF ( ¡ )
REW ( 1 )
3
2
– a
4
2
– b
POWER
PAUSE ( 8 )
It may be unlawful to record or play back
copyrighted material without the consent of the
copyright owner.
S-VHS/VHS Recording
1 Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape before
inserting the cassette.
2 Select recording channel
On the front panel:
Press CH + or –.
On the Remote:
a– Press CH + or –.
or
b– Press the Number keys.
3 Set tape speed
Press HS/STD/LS3/SP/EP ( ) to set the
recording speed.
4 Start recording
On the front panel:
Press REC (
¶ ).
On the Remote:
While holding REC (
¶ ), press PLAY ( 3 ).
● If “V, CALIBRATION” is set to “ON” (default
setting: ੬ pg. 49), this VCR checks the tape
condition for about seven seconds, then starts
recording. This means that the first seven
seconds of the program will not be recorded. If
this is inconvenient for you, follow the steps
below:
1 Press REC ( ¶ ) and PAUSE ( 8 ) to start
Video Calibration.
2 Then press PLAY ( 3 ) to start recording
after Video Calibration is complete.
BASIC PLAYBACK AND RECORDING (cont.)
2
3
STOP/EJECT
( 7 / 0 )
POWER
4
VDA300U-EN21-33 03.3.12, 4:15 PM 26