John Lewis JLBIDOS904 - Manual (Page 28)

28
)
)
Under no circumstances should the door
assembly be detached from the product for
cleaning.
How to Remove the Inner
Glass
1.
Open the oven door slightly to gain access to the
two cross head screws on the top of the oven door.
2. Loosen the two screws using a Pozidrive
screwdriver.
3. Holding the door glass securely in place with one
hand remove the screws and washers with the other
hand.
The screws and washers retain the trim on the top
of the grill door. Note the position of the trim on
the door.
4. Holding the door and glass with one hand, gently pull
towards you and slightly lift the door glass with the
other hand to disengage the panel from the location
point at the bottom of the door. Gently release the
door to close it.
5. Clean the outer and inner glass using hot soapy
water or Hob Brite. Should the inner face of the
outer door glass be heavily soiled it is recommended
that soapy water with a high concentration of soap is
used. To prevent streaking a glass cleaning spray may
be applied and the glass polished with a soft cloth.
Ensure that all parts are thoroughly dry before
attempting to replace the outer door glass.
If the door glass panel becomes chipped or
has deep scratches the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
Please contact your local Service Force
Centre who will be pleased to advise
further.
How to Replace the Outer
Door Glass
1.
Holding the oven glass with both hands, gently place
the locators into the holes of the brackets at the
bottom of the oven door.
2. Holding the door glass with your left hand, use your
right hand to open the oven door.
Bring the door gently towards the glass panel
ensuring the screw location holes line up.
3. Place the trim in the correct position on the top of
the grill door.
4. Hold the glass in place with one hand and insert the
cross head screws with washers into the location
holes with the other hand. Give the screws one
turn to ensure the glass is secure.
5. Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
Do not attempt to use the oven without
the glass being in place.